少尉
- 注册时间
- 2010-6-22
- 金币
- 156 个
- 威望
- 4 个
- 荣誉
- 0 个
累计签到：4 天
连续签到：1 天
[LV.20]漫游旅程
|
本帖最后由 lanyu 于 2013-3-29 21:39 编辑
我的mw300r v4，终端连接的时候怎么没有看到按Ctrl+C停止启动呢，一上电不管怎么按Ctrl+C，路由也会自动启动。不知为何？
显示信息如下：
U-Boot 1.1.4 (Oct 15 2012 - 02:48:06)
Reserving 36 Bytes for Global Data at: 80fabfb0
Reserving 128k for boot params() at: 80f8bfb0
Bytes for Board Info at: 80fabfd4
Stack Pointer at: 80f8bf98 Now running in RAM - U-Boot at: 80fdc000
Flash Manuf Id
In: serial
, sector count = 64
Flash: 4 MB
Using default environment
Out: serial Err: serial
Net: ag934x_enet_initialize...
wasp reset mask:c03300
WASP ----> S27 PHY
: cfg1 0x80000000 cfg2 0x7114 eth0: ec:88:8f:b4:57:05
athrs27_phy_setup ATHR_PHY_SPEC_STAUS 4 :10
eth0 up
WASP ----> S27 PHY
: cfg1 0xf cfg2 0x7214
eth1: ec:88:8f:b4:57:04
s27 reg init lan
ATHRS27: resetting s27
ATHRS27: s2
athrs27_phy_setup ATHR_PHY_CONTROL 1 :1000
athrs27_phy_setup ATHR_PHY_SPEC_STAUS 1 :10
athrs27_phy_setup ATHR_PHY_CONTROL 2 :1000 athrs27_phy_setup ATHR_PHY_SPEC_STAUS 2 :10
a
Autobooting in 1 seconds
ONTROL 3 :1000
athrs27_phy_setup ATHR_PHY_SPEC_STAUS 3 :10
eth1 up
eth0, eth1
Attaching interface lo0... done
essing...done
Rx clbufs 2048 each of size 1756
eth_rx_netpool_init: allocated, pDmaBuf=0x80b78850, buffend = 80eea854 ATHRS27: resetting s27
ATHRS27: s27 reset done
eth_rx_netpool_init: done already!
interrupt: enet1 port2 up
interrupt: LAN Port Interface type is 0x4c04
usrAppInitEx: 116: GPIO_OE = 30310
Attached IPv4 interface to mirror unit 0
usrAppInitEx: 118: CP0 CONFIG1 = bee3519e
itEx: 117: CP0 CONFIG = 80208483
-->starting wireless...
sysWlanInit ...
APCFG task id 80996b10
AH_CAL_IN_FLASH_AHB
Boostrap clock 25MHz
ar9300RadioAttach: Need analog access recipe!! Restoring Cal data from Flash
ath_get_caps[4703] rx chainmask mismatch actual 3 sc_chai
Entering Task Loop
Entering WLAN event Task Loop
ocated, dmabuf=0x80660650, buffend = 80922854fully at 0x80954070
ERROR:wireless OR ACL disable sending message 806364d0,24
sending message 806364d0,24 TDDP: Now listening client request.
httpInit: System File Registry successfully initialized.
httpInit: System File Manager successfully initialized.
httpInit: File System RPM successfully initialized.
httpInit: RPM dispatcher successfully initialized.
httpInit: http Password Checking successfully initialized.
e guessing RPM successfully initialized.
httpInit: http Access Control successfully initialized.
Software Platform for MIPS
Copyright(C) 2001-2010 by TP-LINK TECHNOLOGIES CO., LTD.
Starting WLAN Creation date: !!!Nov 26 2012, 15:03:40!
# AP_STARTMODE=standard
AP_ENABLE=1
ATH_COUNTRYCODE=156
wlan_vap_create : exit. devhandle=0x80458b10, opmode=IEEE80211_M_HOSTAP, flags=0x1.
osif_ioctl_create_vap: vap 0x80ffe970 vap->iv_unit 0
ieee80211_end_load: load done ath0 end flag = 0x00028802 default
WLAN IOCTL AP_CHMODE=11NGHT40PLUS=11NGHT20=11NGHT40PLUS=1003
IEE80211-MODE IOCTL 1,11NGHT40PLUS,13
NGHT40PLUS
set mode 11,-2130709132,6
set mode retv 0
WLAN IOCTL AP_PRIMARY_CH=auto=6=a
IEE80211-setparam-nobridge 0
WLAN IOCTL AP_TX11NRATE==0x0=0x0=1041
set auto rate
EE80211-SETPURGE IOCTL 0
WLAN IOCTL AP_HIDE_SSID=0=0=0=1005
IEEE80211-SETHIDESSIDIOCTL 0
WLAN IOCTL AP_11G_PROTECTION==0=0=1042
WLAN IOCTL AP_BEACON_INTERVAL=100=100=100=1043
WLAN IOCTL AP_FRAGMENT_THRESHOLD=2346=2346=2346=1044
WLAN IOCTL AP_RTS_THRESHOLD=2346=2347=2346=1046
WLAN IOCTL AP_DTIM_PERIOD=1=1=1=1045
WLAN IOCTL AP_WMM_ENABLE=1=1=1=1051
Get EIOCGADDR
WMM_NOACK==0=0=1052
IOCTL set wmm noack 0
WLAN IOCTL AP_CYPHER_2==CCMP=CCMP=1000
WLAN IOCTL AP_MACFILTER_MODE==0=0=1038
H==0=0=1056
WLAN IOCTL AP_MCASTRATE==0=0=1018
WLAN IOCTL AP_SHORT_GI=1=1=1=1055
WLAN IOCTL AP_DISABLECOEXT=1=0=1=1075
Get EIOCGADDR
WLAN IOCTL AP_SSID=MERCURY_B45704=Ath_AP123ng=MERCURY_B45704=1001
IEE80211-ESSID IOCTL 1,MERCURY_B45704,15
AP_CHMODE=11NGHT40PLUS
AP_CWMMODE=1
IEE80211-CWMMODE IOCTL 1
AP_AMPDU=0
AP_PURE_N=0
AP_TX_CHAINMASK=3
AP_SECMODE=None
WPS_ENABLE=1
AP_MACFILTER_MODE=0
ieee80211_open
WLAN IOCTL AP_BASICRATES==0=0=1039
WLAN IOCTL AP_DEBUG=0=0=0=1062
WPS OPEN BSS init
starting hostapd ...
Hostapd task Created 80ffa4a0
CMODE=None
WPS BSS init
WPS_ENABLE=1
WPS_PIN=11123712 WLAN IOCTL AP_TX_POWER==0=0=1073
Task details [80ffa4a0,,64,809968a8]
Set EIOCGMIB2
default
Entering Hostapd Main
Adding ath0 in bridge ...
default
Attached backend socket for eth0
Attached backend socket for eth1
Attached backend socket for mirror 0 @@@@ kris-hostapd vapid=0 @@@@@ wiface=ath0 @@@@
**** [0,1,0,0192.168.1.2,]****
Just before eloop_run()
*** setup interface1 started ****
1136073607.416667: Defaulted uuid based on mac addr ec:88:8f:b4:57:04
ieee80211_ioctl_setappiebuf
ieee80211_ioctl_setappiebuf
y 0
1136073607.416667: madwifi_start_receive_prob_req Enter
Madwifi init completed
1136073607.433333: ENTER eap_wps_disable, reason=7
*** setup interface1 completed ****
***
[ieee80211_ioctl_setmlme:1887] data=0x80ff9fc0,data->pointer=0x80ffa010, data->length=42
[ieee80211_ioctl_setmlme:1893] mlme->im_op=3
1136073607.450000: Deauthenticate all stations
IEE80211-setparam-privacy 0
ieee80211_ioctl_delkey : idk_keyix=0
ieee80211_ioctl_delkey : idk_keyix=1
ieee80211_ioctl_delkey : idk_keyix=2
ieee80211_ioctl_delkey : idk_k
Using interface ath0 with hwaddr ec:88:8f:b4:57:04 and ssid 'MERCURY_B45704' 1136073607.483333: SSID - hexdump_ascii(len=14):
4d 45 52 43 55 52 59 5f 42 34 35 37 30 34
1136073607.750000: PSK (from passphrase) - hexdump(len=32): c3 98 79 da 2c 5f 37 2f 87 7f 75 45 7d 2f 56 25 17 fd d8 e4 41 1f c8 6d 1f b0 da 8a aa 53 b1 11
IEE80211-ESSID IOCTL
hostapd_ctrl_iface_init
1136073607.800000: upnp_wps_device_init called 1136073607.800000: upnp_wps_device ssdp_listener_start failure!
1136073607.800000: upnp_wps_device_stop ENTER
1136073607.800000: upnp_wps_device_deinit called
1136073607.800000: upnp_wps_device_stop ENTER
1136073607.800000: Continuing with WPS UPnP disabled.
1136073607.800000: Failed to initialize UPnP state machine
****setup interface2 completed****
1136073607.800000: ath0: Setup of interface done.
****setup interface finalized ****
|
|
[复制链接]
IP卡
狗仔卡
发表于 2013-3-24 14:30
显身卡
