[求助]小米 R1C TTL

li0216

Ralink UBoot Version: 4.2.S.1
--------------------------------------------
ASIC 7620_MP (Port5<->None)
DRAM component: 1024 Mbits DDR, width 16
DRAM bus: 16 bit
Total memory: 128 MBytes
Flash component: SPI Flash
Date:Feb 18 2016  Time:11:47:41
============================================
icache: sets:512, ways:4, linesz:32 ,total:65536
dcache: sets:256, ways:4, linesz:32 ,total:32768

##### The CPU freq = 580 MHZ ####
estimate memory size =128 Mbytes

Please choose the operation:
   1: Load system code to SDRAM via TFTP.
   2: Load system code then write to Flash via TFTP.
   3: Boot system code via Flash (default).
   4: Entr boot command line interface.
   7: Load Boot Loader code then write to Flash via Serial.
   9: Load Boot Loader code then write to Flash via TFTP.


1 09:31:24 UTC 2018
[    0.000000]
[    0.000000]  The CPU feqenuce set to 580 MHz
[    0.000000]  PCIE: bypass PCIe DLL.
[    0.000000]  PCIE: Elastic buffer control: Addr:0x68 -> 0xB4
[    0.000000]  disable all power about PCIe
[    0.000000] CPU revision is: 00019650 (MIPS 24Kc)
[    0.000000] Software DMA cache coherency
[    0.000000] Determined physical RAM map:
[    0.000000]  memory: 04000000 @ 00000000 (usable)
[    0.000000] User-defined physical RAM map:
[    0.000000]  memory: 08000000 @ 00000000 (usable)
[    0.000000] Zone PFN ranges:
[    0.000000]   Normal   0x00000000 -> 0x00008000
[    0.000000] Movable zone start PFN for each node
[    0.000000] early_node_map[1] active PFN ranges
[    0.000000]     0: 0x00000000 -> 0x00008000

______________________________________________________________



直接就启动了按啥都没有用

^_^点亮^_^

有教程 免拆机刷BREED BREED成功后第一时间备份EEPROM  和编程器固件 然后就可以胡作非为了
注册小米账号 手机小米APP登录要刷的路由器 会提示绑定
然后去官网获取SSH
SSH文件放FAT32格式的U盘 按住RESET上电 路由器黄灯闪5秒后放手
直到网关可以访问
看百度
SCP协议  把BREED传送到TMP
PUTTY 下打命令 mtd -r write /tmp/breed.bin Bootloader 显示REBOOT用针顶住菊花开机
进入BREED
你就成功了
breed.bin 是自己改的名字 好打命令
祝你成功兄弟
详细教程看百度