大家看看这个路由器怎样刷机

mzy

    大家给看看，获取不到ip，开机没有反应，怎样救砖，ttl口在哪里

below63

反面应该有闪存

x1060703191

我说这货咋这么熟悉 我有个一模一样的路由器刷breed根本启动不了只能刷原厂才行 ！！我有保存这个原厂固件 这个叫  智能商业网关    N200-GA100i-CG500U

邪恶海盗

第二张图左下角的三个孔应该是TTL...

kxqhy

看第一张的标签位置，我就认出来了，我也有一个，能到登录页面，不知道账号密码，有账号密码的回我下，谢谢！

nnsat

反面再贴个图，直觉是左下角三个孔

林通电器

试试刷superwrt

563345228

Linux version 2.6.31--LSDK-9.2.0_U10.1020 (zhanghaozhong@wireless-2) (gcc versio
n 4.3.3 (GCC) ) #gw-ap-ta40-1.0 Thu Mar 27 11:01:06 CST 2014
flash_size passed from bootloader = 8
arg 1: console=ttyS0,115200
arg 2: root=31:03
arg 3: rootfstype=squashfs
arg 4: init=/sbin/init
arg 5: mtdparts=ath-nor0:256k(u-boot),64k(u-boot-env),1280k(uImage),1152k(versio
n_simple),5120k(version_full),64k(nvram),64k(nvram-bak),128k(jffs2),64k(ART)
arg 6: mem=63M
CPU revision is: 0001974c (MIPS 74Kc)
ath_sys_frequency: cpu srif ddr srif cpu 535 ddr 400 ahb 200
Determined physical RAM map:
memory: 02000000 @ 00000000 (usable)
User-defined physical RAM map:
memory: 03f00000 @ 00000000 (usable)
Initrd not found or empty - disabling initrd
Zone PFN ranges:
  Normal   0x00000000 -> 0x00003f00
Movable zone start PFN for each node
early_node_map[1] active PFN ranges
    0: 0x00000000 -> 0x00003f00
Built 1 zonelists in Zone order, mobility grouping on.  Total pages: 16002
Kernel command line: console=ttyS0,115200 root=31:03 rootfstype=squashfs init=/s
bin/init mtdparts=ath-nor0:256k(u-boot),64k(u-boot-env),1280k(uImage),1152k(vers
ion_simple),5120k(version_full),64k(nvram),64k(nvram-bak),128k(jffs2),64k(ART) m
em=63M
PID hash table entries: 256 (order: 8, 1024 bytes)
Dentry cache hash table entries: 8192 (order: 3, 32768 bytes)
Inode-cache hash table entries: 4096 (order: 2, 16384 bytes)
Primary instruction cache 64kB, VIPT, 4-way, linesize 32 bytes.
Primary data cache 32kB, 4-way, VIPT, cache aliases, linesize 32 bytes
Writing ErrCtl register=00000000
Readback ErrCtl register=00000000
Memory: 60992k/64512k available (2009k kernel code, 3444k reserved, 599k data, 1
60k init, 0k highmem)
NR_IRQS:128
plat_time_init: plat time init done
Console: colour dummy device 80x25
Calibrating delay loop... 266.24 BogoMIPS (lpj=133120)
Mount-cache hash table entries: 512
NET: Registered protocol family 16
bio: create slab <bio-0> at 0
SCSI subsystem initialized
NET: Registered protocol family 2
IP route cache hash table entries: 1024 (order: 0, 4096 bytes)
TCP established hash table entries: 2048 (order: 2, 16384 bytes)
TCP bind hash table entries: 2048 (order: 1, 8192 bytes)
TCP: Hash tables configured (established 2048 bind 2048)
TCP reno registered
NET: Registered protocol family 1
ATH GPIOC major 0
squashfs: version 4.0 (2009/01/31) Phillip Lougher
JFFS2 version 2.2 (NAND) (ZLIB) (RTIME) (c) 2001-2006 Red Hat, Inc.
fuse init (API version 7.12)
msgmni has been set to 119
alg: No test for lzma (lzma-generic)
alg: No test for stdrng (krng)
io scheduler noop registered
io scheduler deadline registered (default)
Serial: 8250/16550 driver, 1 ports, IRQ sharing disabled
serial8250.0: ttyS0 at MMIO 0xb8020000 (irq = 19) is a 16550A
console [ttyS0] enabled
brd: module loaded
9 cmdlinepart partitions found on MTD device ath-nor0
Creating 9 MTD partitions on "ath-nor0":
0x000000000000-0x000000040000 : "u-boot"
0x000000040000-0x000000050000 : "u-boot-env"
0x000000050000-0x000000190000 : "uImage"
0x000000190000-0x0000002b0000 : "version_simple"
0x0000002b0000-0x0000007b0000 : "version_full"
0x0000007b0000-0x0000007c0000 : "nvram"
0x0000007c0000-0x0000007d0000 : "nvram-bak"
0x0000007d0000-0x0000007f0000 : "jffs2"
0x0000007f0000-0x000000800000 : "ART"
TCP cubic registered
NET: Registered protocol family 17
802.1Q VLAN Support v1.8 Ben Greear <greearb@candelatech.com>
All bugs added by David S. Miller <davem@redhat.com>
ath_otp_init: Registering OTP success
ath_clksw_init: Registering Clock Switch Interface success
VFS: Mounted root (squashfs filesystem) readonly on device 31:3.
Freeing unused kernel memory: 160k freed
init started:  BusyBox v1.01 (2013.09.12-19:03+0000) multi-call binary
ATHR_GMAC: Length per segment 1536
ATHR_GMAC: fifo cfg 3 01f00140
ATHR_GMAC: RX TASKLET - Pkts per Intr:100
ATHR_GMAC: Mac address for unit 0:bf7f0000
ATHR_GMAC: ff:ff:ff:ff:ff:ff
mac:0 Registering S27....
ATHR_GMAC: Max segments per packet :   1
ATHR_GMAC: Max tx descriptor count :   40
ATHR_GMAC: Max rx descriptor count :   128
ATHR_GMAC: Mac capability flags    :   2580
ATHR_GMAC: RX TASKLET - Pkts per Intr:100
ATHR_GMAC: Mac address for unit 1:bf7f0006
ATHR_GMAC: ff:ff:ff:ff:ff:ff
mac:1 Registering S27....
ATHR_GMAC: Max segments per packet :   1
ATHR_GMAC: Max tx descriptor count :   40
ATHR_GMAC: Max rx descriptor count :   128
ATHR_GMAC: Mac capability flags    :   2D80
ath_wdt_init: Registering WDT success
athr_gmac_ring_alloc Allocated 640 at 0x83a26000
athr_gmac_ring_alloc Allocated 2048 at 0x8390c000
ATHRS27: resetting s27
ATHRS27: s27 reset done
Setting PHY...
athr_gmac_ring_alloc Allocated 640 at 0x83a26400
athr_gmac_ring_alloc Allocated 2048 at 0x83a1b800
Setting PHY...
/etc/rc.d/run_normal_mod.sh: 46: multicast: not found
Gpioex begin.
state set.
mode set begin.
button: Unknown symbol ap_netlink_send
insmod: cannot insert `/lib/modules/button.ko': Unknown symbol in module (-1): N
o such file or directory
Not reserve ram for blackbox!

PPP generic driver version 2.4.2
PPP BSD Compression module registered
PPP Deflate Compression module registered
NET: Registered protocol family 24
PPPoL2TP kernel driver, V1.0
/usr/sbin/startup: 85: cannot create /proc/sys/net/ipv4/netfilter/ip_conntrack_t
cp_timeout_established: Directory nonexistent
insmod: cannot open module `/lib/modules/bridge.ko': No such file or directory
insmod: cannot open module `/lib/modules/flowctrl.ko': No such file or directory

user_file_writepen userfile error
record_hardreboot, open file(/proc/userfile) error.
cat: /tmp/rebootrecord: No such file or directory
cat: /tmp/rebootrecord: No such file or directory
cat: /tmp/rebootrecord: No such file or directory
cat: /tmp/rebootrecord: No such file or directory
cat: /tmp/rebootrecord: No such file or directory
Set OK!
Set OK!
Set OK!
Set OK!
Set OK!
Set OK!
Set OK!
Set OK!
Set OK!
Set OK!
Set OK!
Set OK!
Set OK!
Set OK!
Set OK!
Set OK!
Set OK!
athr_gmac_ring_free Freeing at 0x83a26400
athr_gmac_ring_free Freeing at 0x83a1b800
athr_gmac_ring_free Freeing at 0x83a26000
athr_gmac_ring_free Freeing at 0x8390c000
athr_gmac_ring_alloc Allocated 640 at 0x83a26000
athr_gmac_ring_alloc Allocated 2048 at 0x8390c000
Setting PHY...
athr_gmac_ring_alloc Allocated 640 at 0x83a26400

cmd360

你倒是上张背面图啊，直接拆闪存刷就行了

天意楼主

9344有吗固件

清风与狗

我有个刷成砖了。。。。。。。

fgxs

我觉得这样可以获得金币