r550，web页面升级故障

felix_pipi

r550，web升级固件，没有跨版本升级，正常升级，一直卡再正在处理，反复重置也没有作用

leiclye

切换到火狐浏览器.

felix_pipi

leiclye 发表于 2025-5-23 17:19
切换到火狐浏览器.

换了，也不行，恢复出厂设置，也卡死

ruckus

用SSH升级

felix_pipi

ruckus 发表于 2025-5-24 09:05
用SSH升级

没有fw命令，怎么处理

ruckus

fw set proto tftp
fw set control R550_fw.bl7
fw update IP地址
reboot
运行TFTP软件，IP地址填这个电脑的，将固件和TFTP文件放一起

felix_pipi

ruckus 发表于 2025-5-24 17:52
fw set proto tftp
fw set control R550_fw.bl7
fw update IP地址

The command is either unrecognized or incomplete. To view a list of commands that you can run  from this context, type '?' or 'help'.

felix_pipi

ruckus 发表于 2025-5-24 17:52
fw set proto tftp
fw set control R550_fw.bl7
fw update IP地址

ruckus#
  exit                 Ends the CLI session.
  help                 Shows available commands.
  quit                 Ends the CLI session.
  history              Shows a list of previously run commands.
  disable              Disables privileged commands.
  ping <IP-ADDR/DOMAIN-NAME>
                       Sends ICMP echo packets to an IP/IPv6 address or domain name.
  reboot               Reboots the controller.
  shutdown             Shut down ZoneDirector, to power on ZoneDirector again, press the power
                       button. When the Status LED is lit steadily, you can then reconnect to
                       CLI.
  set-factory          Set factory default.
  switch-ap            Set factory default.
  data-privacy         Excutes data-privacy command.
  config               Configures options and settings.
  logo                 Contains commands that can be executed from within the context.
  easyDpl-get-status   Get easy-deployment running status.
  easyDpl-disable      Debug command, please stop easy-deployment by Webpage. This command stops
                       easy-deployment and disables tr069 function, may cause mechanism chaos when
                       easy-deployment is after prepareimage status.
  debug                Manages system debug options.
  show                 Displays system options and settings.
  reset                Reset system options and settings.
  session-timeout <NUMBER>
                       Sets the CLI session timeout.
  ap-mode              Go to local AP's CLI from Master's CLI.
只有这几个命令可以用