dir810l 黄灯，ttl无选择项
有大神给看看这是怎么回事，ttl看不到启动选择123456。。。U-Boot 1.1.3 (Jan7 2013 - 16:08:08)
Board: Ralink APSoC DRAM:64 MB
relocate_code Pointer at: 83f98000
enable ephy clock...done. rf reg 29 = 5
SSC disabled.
spi_wait_nsec: 29
spi device id: c2 20 17 c2 20 (2017c220)
find flash: MX25L6405D
MAC: 8c:88:2b:00:00:04
============================================
Ralink UBoot Version: 4.1.1.0
<NULL>(1.00b03)
--------------------------------------------
ASIC 7620_MP (Port5<->None)
DRAM component: 512 Mbits DDR, width 16
DRAM bus: 16 bit
Total memory: 64 MBytes
Flash component: SPI Flash
Date:Jan7 2013Time:16:08:08
============================================
icache: sets:512, ways:4, linesz:32 ,total:65536
dcache: sets:256, ways:4, linesz:32 ,total:32768
##### The CPU freq = 580 MHZ ####
estimate memory size =64 Mbytes
3: System Boot system code via Flash.
## Booting image at bc170000 ...
Bad Magic Number,70B93FE7
安复位键卡机显示
U-Boot 1.1.3 (Jan7 2013 - 16:08:08)
Board: Ralink APSoC DRAM:64 MB
relocate_code Pointer at: 83f98000
enable ephy clock...done. rf reg 29 = 5
SSC disabled.
spi_wait_nsec: 29
spi device id: c2 20 17 c2 20 (2017c220)
find flash: MX25L6405D
MAC: 8c:88:2b:00:00:04
============================================
Ralink UBoot Version: 4.1.1.0
<NULL>(1.00b03)
--------------------------------------------
ASIC 7620_MP (Port5<->None)
DRAM component: 512 Mbits DDR, width 16
DRAM bus: 16 bit
Total memory: 64 MBytes
Flash component: SPI Flash
Date:Jan7 2013Time:16:08:08
============================================
icache: sets:512, ways:4, linesz:32 ,total:65536
dcache: sets:256, ways:4, linesz:32 ,total:32768
##### The CPU freq = 580 MHZ ####
estimate memory size =64 Mbytes
4 3 2 1
!!! Entering Emergency Mode !!!
netboot_common, argc= 1
NetTxPacket = 0x83FD3180
KSEG1ADDR(NetTxPacket) = 0xA3FD3180
NetLoop,call eth_halt !
NetLoop,call eth_init !
Trying Eth0 (10/100-M)
Waitting for RX_DMA_BUSY status Start... done
ETH_STATE_ACTIVE!!
uip init ...
httpd init ...
fs_init(Entry)
页:
[1]