这个路由器还有救么TTL怎么修

cityofthesky

1. U-Boot 1.1.3 (Jul 24 2014 - 14:22:10)
   
2. 
   
3. Board: Ralink APSoC DRAM:  64 MB
   
4. relocate_code Pointer at: 83fb8000
   
5. enable ephy clock...done. rf reg 29 = 5
   
6. SSC disabled.
   
7. ******************************
   
8. Software System Reset Occurred
   
9. ******************************
   
10. spi_wait_nsec: 29
    
11. spi device id: ef 40 17 0 0 (40170000)
    
12. find flash: W25Q64BV
    
13. raspi_read: from:30000 len:1000
    
14. *** Warning - bad CRC, using default environment
    
15. 
    
16. ============================================
    
17. Ralink UBoot Version: 4.2.S.1
    
18. --------------------------------------------
    
19. ASIC 7620_MP (Port5<->None)
    
20. DRAM component: 512 Mbits DDR, width 16
    
21. DRAM bus: 16 bit
    
22. Total memory: 64 MBytes
    
23. Flash component: SPI Flash
    
24. Date:Jul 24 2014  Time:14:22:10
    
25. ============================================
    
26. icache: sets:512, ways:4, linesz:32 ,total:65536
    
27. dcache: sets:256, ways:4, linesz:32 ,total:32768
    
28. 
    
29. ##### The CPU freq = 580 MHZ ####
    
30. estimate memory size =64 Mbytes
    
31. 
    
32. Please choose the operation:
    
33.    1: Load system code to SDRAM via TFTP.
    
34.    2: Load system code then write to Flash via TFTP.
    
35.    3: Boot system code via Flash (default).
    
36.    4: Entr boot command line interface.
    
37.    7: Load Boot Loader code then write to Flash via Serial.
    
38.    9: Load Boot Loader code then write to Flash via TFTP.
    
39. 
    
40. RALINK_REG(RT2880_GPIOMODE_REG)1 value is 1716508
    
41. 
    
42. 
    
43. RALINK_REG(RT2880_GPIOMODE_REG)2 value is 1708317
    
44. 
    
45. 
    
46. RT2880_REG_PIODATA value is 16547719
    
47. 
    
48. 0
    
49.    
    
50. 3: System Boot system code via Flash.
    
51. ## Booting image at bc050000 ...
    
52. raspi_read: from:50000 len:40
    
53. Bad Magic Number,48445230
    

复制代码

邪恶海盗

Please choose the operation:
   1: Load system code to SDRAM via TFTP.
   2: Load system code then write to Flash via TFTP.
   3: Boot system code via Flash (default).
   4: Entr boot command line interface.
   7: Load Boot Loader code then write to Flash via Serial.
   9: Load Boot Loader code then write to Flash via TFTP.

按2刷固件

mazda520

我的到
find flash: W25Q64BV
就停着了

这样才是挂了