少尉
- 注册时间
- 2010-8-10
- 金币
- 304 个
- 威望
- 1 个
- 荣誉
- 0 个
累计签到:4 天 连续签到:0 天 [LV.20]漫游旅程
|
发表于 2013-11-8 21:21
U-Boot 1.1.3 (Nov 4 2009 - 18:13:51)
Board: Ralink APSoC DRAM: 16 MB
relocate_code Pointer at: 80fb0000
flash_protect ON: from 0xBF000000 to 0xBF01D423
flash_protect ON: from 0xBF030000 to 0xBF030FFF
*** Warning - bad CRC, using default environment
============================================
Ralink UBoot Version: 3.3
--------------------------------------------
ASIC 3052_MP2 (Port5<->None)
DRAM component: 128 Mbits SDR
DRAM bus: 16 bit
Total memory: 16 MBytes
Flash component: NOR Flash
Date:Nov 4 2009 Time:18:13:51
============================================
icache: sets:256, ways:4, linesz:32 ,total:32768
dcache: sets:128, ways:4, linesz:32 ,total:16384
##### The CPU freq = 320 MHZ ####
SDRAM bus set to 16 bit
SDRAM size =16 Mbytes
Please choose the operation:
1: Load system code to SDRAM via TFTP.
2: Load system code then write to Flash via TFTP.
3: Boot system code via Flash (default).
4: Entr boot command line interface.
9: Load Boot Loader code then write to Flash via TFTP.
You choosed 3
0
3: System Boot system code via Flash.
## Booting image at bf050000 ...
Image Name:
Created: 2011-09-30 3:41:53 UTC
Image Type: MIPS Linux Kernel Image (lzma compressed)
Data Size: 3771244 Bytes = 3.6 MB
Load Address: 80000000
Entry Point: 80324000
Verifying Checksum ... OK
Uncompressing Kernel Image ... OK
No initrd
## Transferring control to Linux (at address 80324000) ...
## Giving linux memsize in MB, 16
Starting kernel ...
鎬榾鄻啒鴺fff橒~嗻~fx鴨鴨鴨鎬榾鎬榾f |
|